 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bryant 383kav furnace won't run
No error codes. Only code 11. I've run all the suggested tests I could find. The inducer motor runs. The igniter ignites. The blower runs. My furnace does have something I've haven't seen discussed anywhere. When it was installed they couldn't get a liner in the chimney so they power vented it out of the side of the house. There is a wire that runs from the power vent motor and ties in with the thermostat wires. I'm not getting any power through the thermostat wires, even right at the control board. I'm wondering if the vent must power up before power is sent to the thermostat so to keep the furnace from starting if the power vent is not operating.
|
||||
Check out some similar questions!
I'm not getting any error led blips from the computer board. I can only see one limit switch which isn't tripped. I replaced the thermostat but that wasn't it. I've checked breakers and even tried tripping them off and then back on. Usually if I remember right this furnace goes through a...
I have a Bryant 383KAV. When I install the bottom panel the blower runs for about 90 seconds. Once the blower runs for 90 seconds, the inducer fan will start up and then I hear the click that would typically begin the process of heating up the Ignitor. After about 7 seconds or so, I can...
For the last two nights (very cold weather) our Bryant Furnace appears to be attempting to start, fan kicks in and the burners ignite then it shuts off 2-3 seconds later this happens repeatedly. The first night (around 3 am) I noticed this I turned the heat off with the thermostat and left it for...
Hi, My Bryant 383KAV gas furnace does not work. The RED light (start) does not come on. There is 24 V current coming out of TRANSFORMER into the board. By the way the board fuse is fine. So I'm not sure if the board is the problem. PLease help. Thank you, Dave
Still scratching my head on this one. Everything appears to be working fine on my furnace, except that the ignitor is not getting juice to glow orange/white, hence the gas is not igniting? I disconnected the ignitor harness from the control board, ran the test sequence again, and determined that I...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
