 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
I need to change my blower speed on a lennox elite furnace. How to set up wires for slower speed
Have lennox G20 Q4 furnace. Burners work when called for but no blower. Blower will not run when selected at thermostat. Had a new circuit board for the G20 Q3 furnace, installed it. Result was blower ran prior to burners igniting and blower would not go off after burner shut down. Changed...
Excuse my lack of mechanical knowledge and I hope I can explain the problem in an understandable way. The blower on the electric furnace has gotten out of alignment(?) and is rubbing the housing(?). I can put it in the correct position so it does not rub by physically holding the shaft but cannot...
My mom has an oil fired furnace that just stopped working. I replaced the transformer(white rodgers) that has the connections for the Thermostat,flame detector,etc. That didn't fix the problem. I have hit the reset button and that doesn't work either. At one point,I rotated the Fan Limit switch...
I have a problem with my furnace blower. You can hear it trying to start but it doesn't. It's a 115V motor, 1/3 hp, 6.6A. I put an amp meter on hot leading to motor and it drew 20.9Amps. What could it be? The motor is not seized because I am able to turn the pulley by hand. Could the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
