 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Honeywell t475a control
Im a hvac tech new to hydronic systems was doing a heating inspection on a 1950s bryant copper tube boiler closed loop system with 2 zones not sure how control works no information at homeowners.It was set for 90 degrees and had a senseing bulb going outdoors and another senseing bulb going inside boiler cabinet I believe on one of the copper tube supply at top of boiler.not sure what they are trying to control?a constant loop temp. of 90 degrees? Would appriciate any help.Thanks
|
||||
Check out some similar questions!
I'm installing an additional transformer to power the zone control panel & dampers. Can I just "tie" into the existing 120 power supply that is connected to a shut off switch that is attached to the furnace?
I'm installing a Honewell zone control system (Honeywell HZ311K 1 Heat / 1 Cool TrueZONE Zoning Kit). The kit comes with a low volt transformer, but my existing furnace has an onboard transformer wired into it. Do I need to install the second transformer just to be able to run the control panel...
Residential gas unit blows constant cool air honeywell pilot lite will not work
I have a new honeywell gas valve for my furnace M# VR8345M 4302. I am trying to use a Johnson Ignition Control G770 MGC-3 to operate This valve. The problem is I want to use the intermittent function of this honeywell valve And the johnson igniter control has no provision for the mv/pv on the...
Closed loop hydronic system boiler( GAS) with reset thermosat and watts flowswitch I have Old Honeywell T475A thermosate which I would to replace and install new one honeywell L60061034. This one will go on boiler inlet Cu pipe (Surfacemount thermostat) Existing thermosat is connected between...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
