Ask Experts Questions for FREE Help !
Ask
    borilla's Avatar
    borilla Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 31, 2008, 06:20 AM
    Honeywell gas pilot ignition control
    Residential gas unit blows constant cool air honeywell pilot lite will not work
    21boat's Avatar
    21boat Posts: 2,441, Reputation: 212
    Ultra Member
    		  
    #2

    Dec 31, 2008, 07:19 AM
    Lets try to light pilot again
    Set thermostat to call for heat
    Find gas valve See "on" "pilot" "off" turn to off wait 3 min Look for tube to pilot (Use long match or tape match to stick in to pilot.) Turn Knob from "off" to "pilot" or depress knob if that's your setup. Lite pilot, keep button depressed for 60 sec with pilot lit to heat thermo couple. Slowly release look for pilot now lit Then turn gas valve to "ON" and heat should start. If the burner does not ignite its probably the thermocouple couple that needs replaced This device senses heat at the LIT pilot to let the gas valve turn on fully to heat furnace safety device. If you try this a couple of times the thermocouple couple is bad or your not getting gas or the gas valve is bad which is very rare

    Signed 21 boat

    If my answer has helped please rate my answer
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring changes: Johnson Controls G600AX-1 With Honeywell S8610U Gas Ignition Control [ 7 Answers ]

This is my very first post so... Hello everyone. and here is my question: I am replacing a Johnson Controls Pilot Gas Ignition control unit with a Honeywell 8610U and I am a little confused on how to connect all the wires. The wiring on the Johnson Controls unit is as follows: Main Valve...

Lennox Ignition Pilot Control Module [ 3 Answers ]

My problem with my Lennox furnace (model G23Q-3/4-100-2) is blowing cool air, and only occasionally heat was diagnosed as needing a Universal Pilot Module, part #53L9001 also known as 53L90. Question, if we purchase the part how difficult is the installation?

S8610U Universal intermittent pilot gas ignition control. [ 2 Answers ]

I wire the module up correctly and have 24V to module but no spark or led fault lights. The exhaust fan starts up and ignition sequence starts but no spark. Suggestions or exsperience with this module. Thks Mike

Intermittent Pilot Ignition Control Wiring Help? [ 2 Answers ]

I have an older Carrier gas furnace. The Intermittent Pilot Ignition Control is short cycling. I ordered a replacement one. However, with everything else now days, the newer one does not match the older one. The older one (p/n 50D49-401) has three brown wires, one red wire, one white wire, one...

View more questions Search