 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
We have a Goodman Furnace GMP075-3 which we replaced the gas valve and flame sensor in 2008 for the same problem that I am about to describe that is currently happening AGAIN! The funace kicks on, it ignites, flame goes out and fan continues to run blowing cold. This happens intermittently NOW,...
When it starts up everything appears normal, the induced draft fan starts for about 30 seconds, the glow plug gets red hot, the gas ignites, about 30 seconds later the main blower wheel spins. The hot air comes out of the registers and everything works great but only for about 5 minutes, then for...
the furnace is tripping on high limit , not rollout. It will initiate a call for heat. The flue fan will run the air switch will make and the ignitor will glow. The MV comes on and the furnace lights. It continues to run for appr. 2 minutes and the high limit will open. It is not a variable high...
Hi , my goodman furnace gmp075 3 furnace ,inducer turns on ignitor glows ,burners fire for about 5-7 sec,then turn off blower doesn't come on,but if I let it cycle about 5 times then the blower does come on and it works fine,can anyone tell me what's wrong, thank you
Had a Heating Co. check my furnace. They found heat exchange cracked at heat exhange-burner entry venturi point and main center roll out missing. They said we should replace. Does that sound correct? Is the furnace safe to run?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
