Ask Experts Questions for FREE Help !
Ask
    vince2323's Avatar
    vince2323 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 7, 2010, 05:24 PM
    Cross over wire in 240 volt heaters?
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
    		  
    #2

    Oct 7, 2010, 06:14 PM

    Going to need a little more info for the pros here to help you out.
    vince2323's Avatar
    vince2323 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Oct 7, 2010, 06:29 PM
    Comment on mygirlsdad77's post
    Heaters manufactured 1970 to 1986 have a cross over wire which might degrade over time and fail as a result and possibly cause fire notice from our village assoc. what is this wire and where is it in the base board heater 240 volts??
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Required circuit breaker size for 240 volt dayton 3UG73 electric heaters [ 11 Answers ]

What size breaker should be used for a dayton 3UG73 electric heater , wired for 240 volts

240 Volt 3 Wire Service to 4-Wire Receptical [ 4 Answers ]

I am replacing an electrical stove with a new electrical range. The old stove was hard wired with a 3-wire service. I assume 2 hot and a ground). The new range requires a 4-wire receptical (I assume 2 hot, neutral & ground). Can I wire the 3-wire service to the 4-wire receptical? (How do I do...

Can you install more than one 240 volt heaters on a breaker [ 1 Answers ]

We are trying to update the heaters in our house and currently have baseboard heat and were going to use the Cadet wall heaters. Currently all the heaters in the house are on 1 breaker (10 baseboard) is that safe should we split them up as we update?

Electric 240 Volt Wall Heaters [ 1 Answers ]

On on 30-amp 240V circuit I have (2000w, 1500, 1500, and 500w wall heaters) which adds up to 5500 walts. Two wire are going to the breaker Black, Red, and then the ground. If both the red and black are hot shouldn't there be a white for the return or to complete the circuit.

240 volt four wire in 240 three wire outlet [ 1 Answers ]

I have a generator that has (2) 20 amp 110 outlets and (1) 240 outlet. The 240 outlet have receptacle for four wire plug but I want to use it in a three 930 wire 240 volt plug at other end. Is this a workable solution?

View more questions Search