Where is the reset botton for a ultra sx80 furance

Check out some similar questions!

Reset control panel Kenmore ultra wash [ 5 Answers ]

Hi, I have a 3 years old Kenmore Ultra wash dishwasher, I am on my 3rd panel control, last panel was put in Oct. 09 by sears, 4 months later it broke again, they will not honor the part, it is out of the 90 days warranty!! (never buy sears products again... ) I tried resetting the control panel by...

Armstrong Ultra Sx80 A/C burns the transformer [ 2 Answers ]

Tried to run AC for the first time this season (Furnace works fine). After looking around, the transformer was definitely burnt. Bought a new one, swapped it out (after carefully re-connecting the proper wires), and the AC worked. About a day later, transformer burned out again. Bought a new...

Armstrong Ultra SX80 not turning on by iteslf! Circuit Board? [ 1 Answers ]

This all started about a week ago. One night we woke up to a very cold house. The furnace hadn't kicked on at all during the night. It's an Armstrong ultra sx80. It has the automatic ignition. When I went to check on it, I took off the panels and vaccuumed it out and noticed that when I ran the...

Armstrong Ultra SX80 Heat Exchanger Failure [ 7 Answers ]

I recently experienced a series of small explosions while my furnace was operating. After extensive troubleshooting, I discovered the rollout switch was tripped, after I reset it, I watched the furnace startup properly, but as soon as the blower came on, it had extensive blowback tripping the...

Kenmore 6651355 ultra wash reset [ 0 Answers ]

I can not tun on my dishwasher. I have tried reset by switching between high temp and heated dry until all lights illuminate and runs through each cycle briefly. I then attempt to run normal wash and no response. There must be a specific sequence. The owners manual is no help! Any thoughts on this

View more questions Search

Check out some similar questions!

Add your answer here.