Check out some similar questions!
The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman.
[ 8 Answers ]
FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S
Inside blower starts after several clicks?
[ 7 Answers ]
This is a Lennox UHG4-75A-2. The model is 80UHG. Inside blower tries to restart (hear several clicks and occasional "chunk" sounds before the fan starts. It is not dead yet but the clicking is getting more frequent before the fan kicks in. If I turn the thermostat a/c off and switch to fan, the...
Inducer starts, but blower/furnace never fire
[ 6 Answers ]
My furnace suddenly stopped working today. The thermostat triggers properly, and the inducer fan starts running, but furnace never fires and the blower doesn't come on. If I turn the blower on manually at the thermostat, it runs fine. The furnace is an older Payne/Carrier natural gas/forced air...
Inducer motor starts running, but ignition never starts
[ 1 Answers ]
I have a Payne Gas forced air furnace, and it's behavior has changed in the last couple of days, where it never gets past the Inducer motor cycle. When we turn on the thermostat (or even jumper across the "R" and "W" leads on the furnace controller) the inducer motor starts running and keeps...
Trouble Starting, Clicks a few times then starts, power is fine
[ 2 Answers ]
Car:Subaru outback, 98 A while back I went to start it and got the 'click' tried again and it started no prob. A few weeks later same thing, but took a few tries to start, was sluggish to start at first but then turned over. Yesterday it did it again. Clicked about 4-5 times, then a little... View more questions Search
Add your answer here.
|