Gas furnace Concored 80 Plus

Will2222 Posts: 1, Reputation: 1

New Member

Sep 28, 2010, 09:56 AM

Gas furnace Concored 80 Plus

Thermostat activate main blower, but nothing else. Reset causes the LED to blink 7 times. No voltate to induced draft fan, nor to glow plug. Could it be the overheat sensor that went bad?

Check out some similar questions!

My gas furnace doesn't light pilot ilght come on but gas doesn't come on [ 1 Answers ]

Gas furnace doesn't come on the fan for fresh air/exhaust and pilot light comes on but gas valve not letting gas in to burner so it doesn't light,but if I turn off power and back on three or four times it will work until house cools and need heat again

Do trane gas Furnace have belt and how to fix trane gas Furnace [ 1 Answers ]

I have trane gas Furnace and its stopped working the pilot is not working its keep shutting off and also the switch on and off is working but the pilot and burner is not working what should I do ?:(

Carrier Natural Gas Furnace main gas valve will not open every call for heat [ 1 Answers ]

We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:

Gas Furnace - gas will not flow after HSI lights [ 15 Answers ]

Goodman Furnace Direct Ignition - Blower kicks on - pressure switch works - HSI heats up for about 8 secs -- NO GAS - HSI goes out Status light just blinks slowly, continuously until I let go of the panel switch. Gas valve is ON - ball cock is open - plenty of gas pressure (hot water...

View more questions Search

Check out some similar questions!

Add your answer here.