Ask Experts Questions for FREE Help !
Ask
    airconditionig's Avatar
    airconditionig Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 23, 2010, 11:56 AM
    No gas flow shown on sight glas ,eev seems to be not activated(24v) what to do?
    Chiller was displaying low evaporating pressure,I fixed a leak vacuumsystem and regas there after it displayed high condensing pressure,can I replace eev ?

Check out some similar questions!

Interruptions in gas flow in Trane XL80 furnace. [ 3 Answers ]

Hi all. I have a Trane XL80 two stage forced hot air furnace, which is 9 years old. Last winter I found the furnace blower running, but the burners were off. Following directions that I read on one of the handyman forums, I cleaned the thermal control device (the little metal rod in the gas/flame...

Gas Furnace - gas will not flow after HSI lights [ 15 Answers ]

Goodman Furnace Direct Ignition - Blower kicks on - pressure switch works - HSI heats up for about 8 secs -- NO GAS - HSI goes out Status light just blinks slowly, continuously until I let go of the panel switch. Gas valve is ON - ball cock is open - plenty of gas pressure (hot water...

No 24v to Main Gas Valve Solenoid [ 8 Answers ]

I have an American Standard Furnace Freedom 80 Comfort-R The Main Gas Valve Solenoid does not energize, no 24volts from the "Pressure switch 2nd stage". . The "lo fire" 1st stage solenoid ALWAYS gets 24v after pilot light is on for 20 seconds. The "hi fire" 2nd stage solenoid does not get 24v...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.