Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Parallel lugs to feed panel from existing
[ 0 Answers ]
I currently have a Squared D 3 phase 400A NQM style main breaker inside a panel. The panel is now essentially full and I want to add a sub panel for expansion. The subpanel is 200A. My problem is how ro feed the sub panel. Are there add on kits or lugs to allow this? I even looked at a simple 3...
Can I go from using existing Closet Flg. 4
[ 6 Answers ]
My cement floor in the bathroom has settled over many decades (Cabin) and am pretty sure it's done settleing. I leveled the floor up and now have a 4" gap between existing closet flange (4" ID Sch.40) and new finished floor height. My question is can I keep existing Closet Flg. And add on an...
Dialing in a footing to to build a wall to close in an existing attached garage
[ 1 Answers ]
I'm in nc an inspector called me and told me to dial in a footing where I'm going to build a wall. I might drill about 8 two foot long rods into the existing 18' long footing then lay two #5 continuous rods tied to the rebars. Put some visqueen down. Here in oxford nc carolina they want the footing...
Panel Closet Restrictions
[ 10 Answers ]
First - this is a great site. I've found several informative threads that have helped me out. Thanks. I'm laying out a finished basement bedroom. I've built a sizable (non clothes) closet for the electrical panel and main trap. If I install a bathroom with a sewage ejector pump/uplush...
How to build a adjustable jig for a raised panel
[ 2 Answers ]
Was just curious that if anyone here has ever built a jig to route raised panel doors and how they did it. I'm working on one now but it needs to be adjustable for different size doors. Any ideas are appreciated. Thanks Nichols Trim View more questions Search
|