Ask Experts Questions for FREE Help !
Ask
    dlwebb's Avatar
    dlwebb Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 5, 2010, 11:17 AM
    Parallel lugs to feed panel from existing
    I currently have a Squared D 3 phase 400A NQM style main breaker inside a panel. The panel is now essentially full and I want to add a sub panel for expansion. The subpanel is 200A. My problem is how ro feed the sub panel. Are there add on kits or lugs to allow this? I even looked at a simple 3 pole 200A braeker to install in the main panel, but as with most applications, these breaker drop off at 150A. Ideas?

Check out some similar questions!

Can a 2nd sub panel be feed from same feed as first? [ 2 Answers ]

I have a 200A main box out on a pole in the yard. I trenched and ran 4/0 aluminum to fee the subpanel on the house. Sadly I installed a smallish box and now I am out of breaker slots (too many 240's... ) Can I tap off the feed from the main box and run it to another subpanel or do I have to install...

Breaker to feed a sub panel [ 3 Answers ]

Hello All, I have run out of room on my main panel and was planning to run a sub panel to the back of the house, about 25ft. Is there a specific type of breaker needed to run a connection to a sub panel? I have an unused 50/50 amp breaker (See picture) that I was planning to use. All the...

Sub panel feed to an exterior building [ 4 Answers ]

For the last week I have been pouring over 10s maybe 100s of threads describing how to do this. I have come a long way but I still have a few questions. My plan so far... I will install a dual pole 60A breaker in my main 100A panel in the basement. From there I will run 4 #6 THHN wires (2...

Sub panel feed wire gauge [ 1 Answers ]

I am adding a sub panel to a new garage addition. New 125 amp panel with a double 50 amp breaker in the existing panel. The new sub panel will be 75 feet from the existing main panel. My concern is the correct wire gauge because of the length of the run. The cable will be inside underfloor then in...

How to tighten Main Lugs in panel to proper torque [ 1 Answers ]

The Square-D panels I'm using have a hex nuts that can only be tightened with an hex tool (aka allen key/wrench). There is a 50 lb/ft suggested torque specification for this nut. I have torque wrenches for normal sockets but not for a hex nut. Wonder if there exists a special torque wrench (or...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.