Ask Experts Questions for FREE Help !
Ask
    PennyandRich's Avatar
    PennyandRich Posts: 3, Reputation: 1
    New Member
     
    #1

    Aug 24, 2010, 02:32 PM
    Removing shower drainage
    We want to remove our shower. How do we block off the waste?

    Thanks
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Aug 24, 2010, 04:30 PM

    What type of material is the drain pipe (pvc, abs, copper, galvanized, cast iron)? Is this drain in concrete, or is it accessible from below the floor?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #3

    Aug 24, 2010, 04:31 PM

    Hi guys...

    It should be as easy as removing the shower unit/floor and then capping the waste and the water lines.

    For the water lines you can shut the water supply off, cut the pipes to a spot that you want them to stop and then cap them off with SHARKBITE (or gatorbite) push-type caps (see image). Here, you install the caps by simply pushing them onto the pipes.. no soldering needed... :) They are sold at all home supply stores.

    For the waste pipe you'll want to cut the pipe off so it is below the floor and then install a cap... if ABS or PVC plastic pipes/fittings you'll prime/cement a cap in place. If other than ABS or PVC let me know the piping material and I'll let you know how to cap it off.

    Back to you...

    Mark

    HI MGD77...posting at same time as you!!
    Attached Images
      
    PennyandRich's Avatar
    PennyandRich Posts: 3, Reputation: 1
    New Member
     
    #4

    Sep 19, 2010, 07:48 AM

    Thanks for your help!
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #5

    Sep 19, 2010, 08:00 AM

    Will this be permeate or temporary? Why are you removing it? Back to you, Tom
    PennyandRich's Avatar
    PennyandRich Posts: 3, Reputation: 1
    New Member
     
    #6

    Sep 19, 2010, 12:08 PM

    It is to be perminant. We have a tiny bathroom, so are removing the shower and spinning the bath around to go under the shower to creat more space.
    Not a clue about the type of pipe but it was only put in 4 years ago in a new build and is upstairs so not set in concrete.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #7

    Sep 19, 2010, 12:45 PM

    Not a clue about the type of pipe
    Open up the vanity cabinet and look at the trap and the pipe coming out of the wall. ABS. PVC or copper? Back to you, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Outdoor Shower Drainage [ 2 Answers ]

We just bought a raised ranch in a RI with an outdoor shower. The lower level of the house has seemed damped, and a dehumidifier has been helping, but this weekend we noticed the carpet in one closet was VERY damp - and it was right next to the wall with the outdoor shower, above! We are thinking...

What can I do to repair slow tub/shower drainage? [ 1 Answers ]

When my bathtub or shower is used the water takes forever to drain out. I have tried using liquid plumber and it helped only slightly. What else can I do?

How to install a new drainage for a shower. [ 1 Answers ]

This will be done in the basement. My concern is how deep the pipes have to be and where I shoud connect this drain?

Removing drain assembly from shower, relacing shower pan [ 1 Answers ]

How do I remove part of the old drain assembly that has been glued to the drain pipe that comes up from the slab floor.

Shower drainage slow [ 4 Answers ]

We removed our old tub/shower and put in a new shower stall only. We moved the shower to the opposite wall and had to move some plumbing and the sewer hook up. The couple times we used it it worked fine. Now it drains very very slowly. This is what we did. We moved the shower drain...


View more questions Search