 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Bathtub Faucet Replacement
I have a garden tub with separate hot and cold fixtures and a spout between. They are mounted on a horizontal surface on the edge of the tub. There is no access to the plumbing under them. I want to replace them but do not know how accomplish that. The spout is the only one with a set screw at the bottom. Can I take a pipe wrench to the fixtures an just unscrew them from the bathtub? If I did would the lift out enough for me to attach a new fixture. What secures these fixtures in the tub? Lot of questions. I am novice but anxious to learn.
John at [email protected] |
||||
Check out some similar questions!
I am trying to replace the bathtub drain and cannot get the old one out. It has been there for approximately 30 years. The directions said to use the handle of a pliers, but my pliers are too wide to fit the slots. Tried other tools, but it won't budge. Is there anything I can use to loosen the...
My problem IS in the diverter. Not matter what you do with the push down valve, most of the water still exits the tub faucet & very little exits the shower faucet. My research has shown that there are 2 types of diverter spouts: slip-on & threaded. Mine must be a slip-on because I feel an...
We are remolding our bathroom and want to install a bathtub that has a larger bathing capacity. The measurements are 30x60 and the bathing area is 24 inches. We want to use the plumbing that is already have.
Is spout offset equal on all spouts
I am about to embark on a rather ambitious 2nd floor bathroom refit at my son's house. The appliances are about 30 years old, and everything is going to be replaced; tub, sink/vanity,toilet, and tiles and gypsum board all around the tub. They have left too many tiles with missing grout for too...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
