Ask Experts Questions for FREE Help !
Ask
    rose10's Avatar
    rose10 Posts: 2, Reputation: 1
    New Member
     
    #1

    Jul 19, 2010, 09:05 AM
    I think we have an overload of outlets to one breaker. Two bedrooms, a living room,
    I think we have an overload of outlets to the same breaker. Two bedrooma, a living room, dining room washroom, and part of a one bedroom apartment all loose power at the same time. When I check the breaker panel, only one is tripped, but all those room looses electricity. We have tripped it ith something as small as a hair dryer or vacuum. We have so many 15 amp breakers in the opanel, what could be connected to them it one breaker is running all those rooms . There is onmly three other room in the hous that are not on that breaker ?
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #2

    Jul 19, 2010, 09:11 AM

    Hi Rose...

    It's amazing but in older homes you will frequently find the overload issues you are presenting. Later, remodels get done and contractors upgrade the electrical according to new codes as best they can within the scope of the new job(s).

    As an example, in an older home we might walk on a job to do a new kitchen remodel and new codes will dictate that the stove, refrigerator, dishwasher, disposal, lights... just about everything in fact... gets its own separate breaker. Homeowner's think we're nuts sometimes because, much like in your case, everything in the kitchen is running just fine off one or two circuits! Fact is, however, the changes are good changes!

    I would recommend that you call in a couple electricians in your area and have them see if there is a reasonable way to reduce the load on the breaker that is there now. It will most likely require some new wiring and a few new breakers being added to the panel.

    Any more questions let us know... OK?

    Mark
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
     
    #3

    Jul 19, 2010, 09:40 AM

    Good afternoon Rose,

    Mark gave you some decent advice with respect to getting a calculated load done by a licensed electrician


    For the record though, neither a vacuum nor a hair dryer a small loads.

    The vacuum gets a large inrush of amperage to get the motor going.

    A hairdryer is a large drain also. First to run the blower motor and then to generate the heat.

    How old is your home? Do you own the home or are you leasing (if you are leasing, then it is only the landlord that can make electrical changes, not the occupant).

    What is the size of your home in sq. feet (estimate)? Do you know the size of your electrical service?

    You might want to consider having a licensed electrician split the load on the circuit, providing you have breaker space available (assuming you have a breaker panel with space in it)
    Angrycustomer's Avatar
    Angrycustomer Posts: 79, Reputation: -1
    Junior Member
     
    #4

    Jul 19, 2010, 11:35 AM

    What you need to do is get the new kenmore 5bj5hd dirt generation system!

    LOL, wish they did make a home fuel cell to generate power! Imagine a whole block with fuel cells selling back their power to the utility so they can get a credit from the state.. everybody wins.

    Honestly, a rewire is your starting point but you have to consider equipment when doing that. 100 amp panel and a 50 amp sub panel is probably what they'll change.
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
     
    #5

    Jul 19, 2010, 11:51 AM

    Mark and Don gave u a goody. Have an electric contractor check out your system and get 3 bids before starting any work.

    Chuck

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Two rooms on same breaker,lost power to one room,other room works [ 6 Answers ]

I replaced the outlets in my spare bedroom, I turned the breaker off before doing it, (the breaker controls both spare and master bedrooms), when I turned the breaker back on, the power in the master bedroom is not working.

Circuit Breaker Overload [ 6 Answers ]

I have a hrose ranch and installed five 500 wattt exterior halogen lights to the barn entry and wash rack areas on an existing 20 amp circuit. After the lights have been on for a few minutes the circuit breaker trips. Obviously, I've over loaded the circuit. My Questions are : Can I change out...

Circuit breaker OK, but no electricity in living room/dining room [ 5 Answers ]

I have a 100 year old farm home. The lights went out in living room and dining room Thanksgiving night. The circuit breaker appears normal and the panel is OK. What went wrong?

Washing machine fried two outlets and lost power in living room [ 5 Answers ]

Hi everyone, I'm not very informed on the electrical workings of a house so please bear with me! Last night my washing machine, located in the laundry room of the basement stopped working. It had been working perfectly up until then. I tested the dryer next to it and it worked and everything...

Circuit Breaker Overload [ 1 Answers ]

I have just installed Heat Tape on my roof to deal with ice damming that has started to take place on my roof (no Cold Roof and I live in Wyoming on a North Facing Slope) Anyway, to plug in the heat tape, I converted an old light fixture into an outlet, and hoped that my problem would be fixed. ...


View more questions Search