Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Texturing walls in new closet
[ 1 Answers ]
Greetings everyone! I have a question about a possible shortcut. I'm finishing the walls in a new closet I built. I plan to tape and mud the joints just once over, rather than going through the effort of really smoothing them out with multiple passes... and as such, I will need to hide the...
Closet bend necessary
[ 3 Answers ]
I am remodeling the bathroom and want to put a new flange on the toilet. The old one is cast iron with oakum? And lead connection to the closet bend. I would like to change to ABS but all the fittings (closet bends) that I find at the retail stores are too deep (>8 in to bottom) and put me below...
Closet Flange
[ 1 Answers ]
I have a 3" PVC closet flange in my basement that is mounted to the cement floor and the flange is cracked in several spots and leaking. How can I repair it without breaking up the cement floor, is there away that I can remove the top of the flange and insert a new one.
Closet Flange
[ 12 Answers ]
I have seen quite a few questions regarding closet flanges but not exactly what I have going on. The toilet in my first floor bathroom has been leaking from the base so I decided to take the opportunity to update the entire bathroom. After removing the toilet I was shocked to find no closet...
Closet Bend
[ 1 Answers ]
Hi All, So, yes, I'm learning about plumbing. Please excuse the basic question... What is unique about a "closet bend" fitting? Also, is it applicable to a wall-mounted rear-drain toilet mounted to a wall with 6-inch studs and a near horizontal drain branch along the wall from the toilet?... View more questions Search
|