Ask Experts Questions for FREE Help !
Ask
    grldwlsn's Avatar
    grldwlsn Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 21, 2010, 04:06 PM
    I have a 1990 honda civic dx 1.5L. I put in new distribitor,car won't start.
    I put in a new distribitor,car won't start. So I put old one kack in still won't start,there is no spark from distribitor to spark plugs
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
    		  
    #2

    Jun 21, 2010, 04:15 PM

    . Power to Distributor Test. Turn ignition OFF. Disconnect the 2-P connector from the distributor. Turn the ignition switch ON. Measure voltage between BLK/YEL (+) terminal and body ground. There should be 12+ volts read. If not, repair open in BLK/YEL wire between the 2-P connector and ignition switch.

    . Check ignition switch for wear, pitting, or melting.

    . Only install a genuine Honda distributor. Over 50% of new aftermarket distributors for Hondas don't work at AMHD.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1990 honda civic will not start [ 1 Answers ]

I own a 1990 Honda civic lx. About 2 months ago it started spitting and sputtering like it had water in the gas, so I put a bottle of heet in it to remove the water and then it just wouldn't start at all after that. I changed out the fuel injectors first and that didn't work, then I found out that...

1990 honda civic won't start [ 1 Answers ]

My 1990 honda civic won't start its getting fuel and spark and the starter is working fine it just won't start. Please help

1990 Honda Civic will not start [ 6 Answers ]

Hello, I have a 1990 Honda Civic that will not start. The radio works, battery is good, I have checked all fuses. I turn the key and the check engine light comes on for 2 seconds then goes off. I can here a relay click behind the radio first, the main relay click by the fuse panel. After...

View more questions Search