Ask Experts Questions for FREE Help !
Ask
    fuzznuttski's Avatar
    fuzznuttski Posts: 19, Reputation: 5
    New Member
    		  
    #1

    Jun 16, 2010, 08:06 PM
    Ryobi 18v cordless drill sparking
    3 y/o drill lost power while applying excess force on screw. Smelled something wrong. Would not perform properly afterwards (very slow speed). It worked (spun briefly) OK 1/2 hr later but w/ blue/green sparks inside motor. Battery OK. Did I permanently damage the drill? Would I cause anymore damage trying to use it? Left it alone.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Jun 16, 2010, 08:12 PM

    Sparking is an indication that the brushes have to be replaced. Unknown if you did any more damage. Exact model #?
    fuzznuttski's Avatar
    fuzznuttski Posts: 19, Reputation: 5
    New Member
    		  
    #3

    Jun 20, 2010, 07:58 PM

    Model # P206
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #4

    Jun 20, 2010, 08:17 PM

    The parts breakdown diagram is here: http://www.ereplacementparts.com/ryo...8051_8064.html

    The motor is available for about $25 not including postage.

    Brushes don't appear to available separately.

    Assuming you didn't damage the gearbox or the switch it's probably not a bad repair.
    fuzznuttski's Avatar
    fuzznuttski Posts: 19, Reputation: 5
    New Member
    		  
    #5

    Jun 21, 2010, 08:25 AM
    Thanks, I'll let you know.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Hitachi cordless drill model number [ 3 Answers ]

I am condsidering purchasing a Hitachi DS18DMR cordlees drill but when I search for it sometimes I see the same model with a PS at the end(Hitachi DS18DMR PS). Does this mean there is a difference?

3/8 in cordless craftsman drill [ 1 Answers ]

I need a chuck assembly this old drill the chuck does not un-screw it is on a geared shaft the gears come off but the chuck is attached to a long shaft with splines and lock rings

What kind of drill do I need to use to drill holes for 1 1/2" pvc plumbing. [ 6 Answers ]

I'm running 1 1/2" pvc for a basement bathroom vanity and a wet bar. Do I need to get a Forstner bit or is just a regular hole saw best for drilling my 2x6 wall studs? Also, is 2" the correct size, or should I go to 2 1/8" or 2 1/4".

Cordless Drill power options [ 9 Answers ]

What is the difference between a 1/2" and 3/8" cordless power drill? Does one have more power than the other, or do they hold different size bits? Which tool would be better to have for average, around the house improvement projects? Not talking about major construction work here. Also, what...

1996 Ford F250HD battery display reads 18V! [ 3 Answers ]

I just noticed yesterday that every once in a while my battery charge meter will suddenly shoot up to 18V (outside of the area marked "NORMAL"), but only stays there for 1-2 seconds then jumps back down to the middle. I am afraid that it might stay there too long and fry something. I understand...

View more questions Search