 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I own a Trane TWE049E13FB1 heat pump (8 years old). The blower motor just went out an
I own a Trane TWE049E13FB1 heat pump (8 years old). The blower motor just went out and I am also told that the 'variable speed motor module' is bad also. The prices I have gotten for replacing the blower motor so far range from $187-$419. I was also quoted a price (from TRANE) of $380 for the 'variable speed motor module'!! For a PC board the size of a playing card!!
I went home and looked at the board again and got some info off them. American Standard, C800796P01, CNT03600. Now, I found CNT03600 on the internet for around $50-$60. Is this the board I need? I |
||||
Check out some similar questions!
Can I use the 800 series thermostat with my XL13i trane heat pump?
How to wire a trane 900 series thermostat to a five wire XL13i heat pump system.
Hi, I was wondering if the Trane XL20i heat pump requires the use of Trane's 900 series thermostat or if a Honeywell VisionPro IAQ thermostat can be used.
I just purchased a goodman heat pump and noticed that the fan cuts on very quickly (like about 2 seconds) after the outside unit cuts on. It seems like it's blowing out cold air at the start and would be beneficial if it could wait more time before blowing air. Is there an easy way to adjust the...
I have an older Rheem heat pump. The blower motor on the outside unit stopped running. It seemed to only run at about half speed for a couple of minutes then get hot and stop. I replaced the motor and both capacitors. This motor runs at full speed but gets hot and stops after a couple of minutes....
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
