Ask Experts Questions for FREE Help !
Ask
    mawalko's Avatar
    mawalko Posts: 1, Reputation: 1
    New Member
     
    #1

    May 27, 2010, 03:40 PM
    Height of angle stop for toilet
    Height of the angle stop on a toilet and the distance from the wall for the toilet ?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    May 27, 2010, 04:03 PM

    Are you asking the distance for the tank or the base. This really depends on which toilet you buy, they come in 10", 12" most of the time. Height of the supply line coing out of the wall is 8" for me, no special code or rule
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #3

    May 27, 2010, 08:50 PM
    Hi all...

    For best fit, the toilet pipe should be 11.5" to the center of the pipe from the finished wall, but most are set at 12" from the finish wall. As ballenger stated, the toilet supply is not a code... depends on the toilet and/or the baseboard you intend to install. 8" as Ballenger suggested works for most cases... :)

    Mark
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #4

    May 28, 2010, 07:50 AM
    Quote Originally Posted by mawalko View Post
    height of the angle stop on a toilet and the distance from the wall for the toilet ?
    Unless it's a one piece toilet we position the toilet angle stop 6" to the left of the center of the drain and 6" up off the floor. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Projectile 8.0 times the speed at maximum height, calculate elevation angle at launch [ 3 Answers ]

The launching speed of a certain projectile is 8.0 times the spped it has at its maximum height. Calculate the elevation angle at launching.

Angle Stop [ 1 Answers ]

Have you heard of an angle stop with a plastic knob that you should pull for water shut off to the fixture? My Mother has these in her house and can't seem to pull them out for water shut off.

Toilet flange bolts make toilet sit at wrong angle [ 2 Answers ]

Previous owners put a bathroom in the rec room. When they installed the toilet flange (to the sewer) it was not aligned with the wall. The toilet sits at a crooked angle, not aligned to the wall. After removing the toilet - the flange that holds the toilet bolt-downs needs to be rotated so...

Angle stop [ 3 Answers ]

What is a standard 1/2" compression angle stop? I am installing a sink faucet supply line

Max height of ball launched at angle [ 1 Answers ]

A golfer hits a golf ball a horizontal distance of 301.5m. What is the max height the ball will reach if it is launched at an angle 25 degrees above the ground?:)


View more questions Search