Ask Experts Questions for FREE Help !
Ask
    mksant's Avatar
    mksant Posts: 22, Reputation: 1
    New Member
    		  
    #1

    May 13, 2010, 05:41 PM
    Edger blades won't turn
    I have a black and decker edger, when I plug it in and engage the start button the blade won't spin a first, but then it will spin real slow but not w/ enough power to do anything how do I fix it?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    May 13, 2010, 05:51 PM

    Try first completely removing the blade, how well does it spin with no blade?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Ceiling fan hums but blades do not turn [ 1 Answers ]

Ceiling fan hums but blades do not turn.I checked the switch connections and wires in the fan itself and all seem to be connected properly. Fan is a hHunter about 4 years old but not used too often

Making blades turn [ 7 Answers ]

Help, 1st of all I have a ceiling fan w/light fixture. The pull chain broke off from the inside, I've replaced the switch. At first the light wouldn't come on either so I switched the black wires. The wire colors are 1 red, 2 blacks & a 1 greenThe light works again but all the ceiling fan does...

Craftsman Lawn Tractor, 2 blades don't turn [ 1 Answers ]

I have a Craftsmand Lawn Tractor 18.5 HP, two of the blades don't turn. When manually turned all three blades turn, could it be the drive belt? Only one blade turns when engaged.

Murray 12.5 40" Blades will not turn [ 2 Answers ]

I have an issue with my riding lawn mower. The motor turns over and the mower itself drives but the blades will not turn. Its probably an easy fix but my mind can't get around how to make the blades rotate. Any help would be appreciated.

Sears rider blades won't turn [ 1 Answers ]

I replace the engine on a used Sears 42", 6 speed riding mower. My problem is that when I engage the blades the engine stalls. The belt, 1/2" wide seems to be in a bind in the engine pulley groove. It will turn the blades if I manually turn the engine in the reverse direction, but not going in...

View more questions Search