Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
B & S 18hp engine dies after warmup
[ 2 Answers ]
B & S 18hp intek engine OHV (vertical shaft) dies after warm-up I have cleared air hole in gas cap, replaced fuel lines and inline filter and all hose clamps. It starts and runs great, but dies after about 10 min. let it sit for a few min. it will start right up and run a little longer. Any ideas...
18hp Briggs Intek - Looses Power Under Load
[ 1 Answers ]
I have a Craftsman L/T 2000 Mower with the B/S 18hp Intek. The engine runs smooth at all throttle positions including full when it is just running. When you start to cut 5" to 6" inch grass the engine seems to loose power. It still runs smooth but full throttle is only at about half, and the mower...
B&s 18hp model 422707
[ 3 Answers ]
Please tell me what wires goes to the solenoid?
B&S 18hp model 422707
[ 4 Answers ]
I need to know if this B&S can be out of time.The flywheel is keyed so I don't know how it could,but I don't know that much about it. Thanks Jack
B&S 18hp model 422707
[ 1 Answers ]
Where does the 2 wires coming from the stator go? View more questions Search
|