Ask Experts Questions for FREE Help !
Ask
    jackman's Avatar
    jackman Posts: 41, Reputation: 1
    Junior Member
    		  
    #1

    Jul 16, 2007, 01:12 PM
    B&S 18hp model 422707
    Where does the 2 wires coming from the stator go?
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Jul 18, 2007, 11:23 AM
    If This Is A Later Model, It Probably Goes To The Fuel Solenoid(on The Bottom Side Of The Carb Bowl) And The Ignition Switch That Goes Back To The Battery.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore elite model quiet guard 7 model 665. [ 12 Answers ]

Six month old dishwasher. Worked fine until today - won't start. LIghts are on and control panel seems to be working OK. The "Clean" indicator is flashing in intervals of 7 flashes and then pauses. When I select the "Start" button it flashes red 3 times and then nothing. The "Drain/Cancel"...

B&S 14HP Model 287707 slow crank starting [ 4 Answers ]

I have a 1992 MTD 1442 riding mower with a B&S 14HP OHV engine MOdel 287707 Type 0153 01 Code 9210214A. It hasn't been starting except with the use of a charger/starter. Engine wouldn't crank but when charger/starter put on it, could get engine started. Now even the charger/starter won't start...

B&S 18hp model 422707 [ 4 Answers ]

I need to know if this B&S can be out of time.The flywheel is keyed so I don't know how it could,but I don't know that much about it. Thanks Jack

Briggs & Stratton 3.5hp Model 98902 [ 2 Answers ]

I have a Bolens Edger with a 3.5 Vertical Shaft Briggs which I purchased used with this problem: After priming the carb, the motor will start (it may take a couple of tries to keep it running) Once it keeps going, the engine seems to oscillate (revs up and dies down, revs up and dies down...

B&S 18HP INTEK Valves/Compression Release [ 1 Answers ]

Am having the same trouble as a lot of others with my 18 hp B&S Intek rider. The motor turns over 1 revolution and stops.Installed new battery and have reset the valve clearance to (.004 intake, 006 exhaust)I remember something about a gummed-up compression release causing this problem ....

View more questions Search