Ask Experts Questions for FREE Help !
Ask
    craftsman99's Avatar
    craftsman99 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    May 2, 2010, 06:33 AM
    Craftsman 6.0 mower will start and run only while pumping the primer. I have replaced
    This 6.0 hp mower model #917.388013,it will start then only runs while you pump the primerbutton.I have replaced the plug, put new hi test gas, dissembled the carb and cleaned every port and the nedle valve at the bottom of the carb. The float has a small spring attached to the neddle . I start it with the air filter off. Please help? Jake
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    May 2, 2010, 12:06 PM

    Hi,
    If you have to push the primer, the jets are still not clean.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Craftsman 17 hp riding mower replaced the solenoid & still no power to engine [ 1 Answers ]

I have a craftsman 17.5 horse riding mower, it was working and I parked it for about a week and now it won't start, the battery if fine.. I replaced the solenoid because there was no power going to the starter. Same preblem with the new one, if I jump the solenoid it will turn over.

My craftsman mower will not start [ 4 Answers ]

I am trying to fix a craftsman mower and it will not turn over. Cleaned the carberator and has new battery. What could be wrong with it?

Craftsman riding mower will start, but will not run [ 1 Answers ]

I have a Craftsman riding mower (42"). It has a 15 hp Kohler engine. It had set up for a while before I got it. I have put a kit in the carburetor, a new solendid valve below the carburetor bowl. I have run a small wire through the bottom where the solendid goes to make sure the jet is clear. ...

Craftsman Mower won't Run on Hills [ 4 Answers ]

I have a craftsman lawn mower and it will not run on a hill. There was gas coming out of the intake when it was on a hill which makes me believe the bowl is overfill. I do not see any way to adjust the float. Any suggestions?

View more questions Search