Ask Experts Questions for FREE Help !
Ask
    westiewhiskey's Avatar
    westiewhiskey Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 20, 2010, 07:45 AM
    Access panel rheem aj series
    How do you get into the rheem aj series air conditioning units, to remove
    Debris and clean and service the fan motor.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Apr 20, 2010, 08:06 AM

    Take the top off.
    westiewhiskey's Avatar
    westiewhiskey Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Apr 21, 2010, 05:12 AM
    Quote Originally Posted by joshdta View Post
    take the top off.
    The fan motor and electrical supply cord is secured to the top of this model rheem air conditioner. Is there an alternative method of accessing the interior of this unit.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Apr 22, 2010, 04:13 AM
    If the top will not work for you the only other option is a side service panel if the unit is so equipped.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

NO HEAT Rheem Classic 90 series 3 years old [ 6 Answers ]

I have a Classic 90 Series Rheem RGRA series upflow/downflow furnace 3 years old. Intermittently, the furnace will not flame up or give out heat. Sometimes it only blows cold air. Sometimes, it locks out (middle green light flashing once then pausing). The furnace repair company came out and...

Rheem Pro Series Dual Fuel. [ 5 Answers ]

Condensate line froze. Replaced and checked drain pan. OK. Fan will blow but unit will not fire burners. Is thbere a reset switch?

Kenmore Dryer (90 series) - Need access to timer panel [ 0 Answers ]

How do you gain access to the timer? Having trouble getting in to the electronic bridge (where the timer and other knobs are) to replace the timer. Have removed screws, but still can't access the timer.

Rheem classic 90 series pilot light [ 2 Answers ]

The pilot light on my furnace went out & I can't figure out how to relight it. It did it a few months ago & my ex (who wasn't my ex at the time) found the instructions & easily got it going again. Since the weather was good I had the thermostat off for about a month just like I always do. Now it is...

Load Panel Access [ 2 Answers ]

I’ve read posts on this board about the required access clearance to the main load panel. My question is, unless I missed it in other posts :o , does the load panel door have to be readily accessible, or more specifically visible? My load panel is attached to the framing in what used to be the...

View more questions Search