 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Gas furnace
I have a Carrier gas furnace model 58BA100-2A. When the thermostat calls for heat, the burner ignites and then the blower comes on (seems normal up to now). The burner only stays lit for a very short time and goes off, so the blower is now blowing cold air into the house. Any ideas on why the burner in only on for such a short time?
Thanks in advance for your help. |
||||
Check out some similar questions!
Gas furnace doesn't come on the fan for fresh air/exhaust and pilot light comes on but gas valve not letting gas in to burner so it doesn't light,but if I turn off power and back on three or four times it will work until house cools and need heat again
I have trane gas Furnace and its stopped working the pilot is not working its keep shutting off and also the switch on and off is working but the pilot and burner is not working what should I do ?:(
We have a Carrier Weather Maker 8000 Natural Gas Furnace not functioning properly. We have replaced pressure switch, hot surface ignitor, flame sensor and control board. It will cycle 3 to 4 times and then not come back on. Is it possibly a bad coil on gas valve?:rolleyes:
Goodman Furnace Direct Ignition - Blower kicks on - pressure switch works - HSI heats up for about 8 secs -- NO GAS - HSI goes out Status light just blinks slowly, continuously until I let go of the panel switch. Gas valve is ON - ball cock is open - plenty of gas pressure (hot water...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
