 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Adding light to existing threeway switch that controls an outlet how do I wire this
There is no lights in family room , added can lights . There are 2 switches that control an outlet. If I run light wire to switch how do I connect the wireing also changed 2 existing switches to switch/dimmers
|
||||
Check out some similar questions!
I want to add a 2nd security light to an existing light switch. There are 2 wires (light brown & white? ) going into the back of the switch. When I hooked the new wiring to the 2 screws on the side of the switch the new lights only operate in the "Off" position and the existing lights now...
Previous owner installed a 220v wire box outside of Garage for Hot tub. It is run through the Garage panel inside to out. Just the wires not outlet. I want to install a 3 wire outlet so I can plug in my 220v welder. Why to I have an extra wire.. One red I assume is hot, one white I assume is...
Howdy. I have a 50 year old house where the bathroom light shares a common wall with the back of the master bedroom closet. I want to add a pull string light in the closet and tap the power off the bathroom light. The bathroom light is switched and the power comes first to the light and then...
I am trying to add 3 pendant lights to the same switch as a light in the room. The power source runs to the light first, then to the switch. I tapped into the wire from the switch to the light. I connected whites to whites, blacks to blacks, and grounds to grounds. Now the pre-existing light...
Hello, my name is Tony I would like to begin with the setup I have in my house, and then ask the question and what I would like to do. First off, in my front entry way of my home, it's approx. 6 years old, so fairly new. I have a set of 4 light switches on the wall, one of them controls outside...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
