Ask Experts Questions for FREE Help !
Ask
    gman61353's Avatar
    gman61353 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 4, 2010, 07:18 AM
    Ameristar Funace pressure switch error
    The pressure switch error just came on on my Ameristar Furnace this morning. I'm unemployed and have to fix it on my own if possible. What are something I can do to remedy this?

Check out some similar questions!

Error code for "open pressure switch" on York natural gas furnace [ 6 Answers ]

I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...

Ameristar A/C unit wiring [ 1 Answers ]

I have an Ameristar Air conditioner unit in the back yard that has three wires that run to the unit in the top rear left hand corner if your looking from the top. The other conduit runs here as well. I was told that these wires are from the thermostat and that its not a difficult fix. My 100 lb....

Tran XB80 error message Pressure Switch erro [ 1 Answers ]

I have a pressure switch error on my Tran furnance- this is causing no call for heat. I replaced the pressure switch and that seemed to work for a couple of days, now its not calling for heat and Im getting the same error. I've cleaned out the drain hose and made sure there are no obstructions. ...

Trane XL90 Pressure Switch Error [ 1 Answers ]

I tried to start up my furnace this weekend and I got 1 click and then a 2nd click and the error code for pressure switch. I need to know what my next step is to disgnose the problem and get it running since the temps are dropping to just above freezing at night now. I had the blower motor...

Goodman gas funace pressure switch problem [ 9 Answers ]

I have a Goodman 93% efficient furnace that short cycles the gas burners. It cycles the vent on, starts the igniter, fires the burners and kicks on the blower but the burners only stay on for a short time ( less than 30 seconds). The led on the circuit board gives me 3 flashes indicating " pressure...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.