 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Newform Enjoy Model 9210 bath Faucet
I just purchased an Newform Enjoy Model 9210 Bath Faucet. The supply hoses " Hot and cold come disconnected from the body. The have a male thread that attaches to the main body. I can crew them in by hand but how do I tighten them?
How do I connect them, do I have to dissaemble the entire faucet, or is there a special tool that can be fitted into this 1i nch hole? I have attached a PDF. Your reply is appreciated. |
||||
Check out some similar questions!
In a difficult and "rigged" installation, a friend installed a single handle Moen bath faucet in my only bathroom. Needless to say, it would be a bear:mad: to remove the entire unit and replace it. Because I live in a rural area, the water well is sometimes unpredictable and has tiny bits of grit...
We cut off water supply for a couple of hours due to remodeling. We also took out the hot water heater. We turned the water back on and have cold water in every room except the bath tub. We have replaced the filter. When we removed the spout water is definitely coming through the pipes, but when we...
My bathroom faucet water smells "funny" sometimes when I first turn the water on. It does not smell coming out of any other faucet in my house. I have taken the screen off and cleaned it, nothing was there. Does anyone know what this could be? Thanks Some how my shower knob will no longer go all...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
