Ask Experts Questions for FREE Help !
Ask
    lfayerman's Avatar
    lfayerman Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 25, 2010, 05:59 PM
    50 A sub panel
    I have a 200A main Load Center. Can I install a 50 A circuit Breaker in the main LOAD CENTER and use for a sub panel a GE load center of 100 A( 12/24).
    hermanwachs's Avatar
    hermanwachs Posts: 28, Reputation: 0
    New Member
     
    #2

    Jan 25, 2010, 06:36 PM

    Yes. Use 6/3 cu and separate the neutral and ground at the subpanel.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do you remove the front toe panel on a Kenmore Elite Dryer? Is is only a panel. [ 1 Answers ]

I need to get under the dryer to replace a heating coil I guess. Dryer Not Drying but I cannot get the toe panel off.

Adding another panel from a 200 amp service panel [ 3 Answers ]

Hi everyone, this is my first post. I have a 60 x 100 ft shop that has a 200 amp service fed in from the pole. Well I added a living space in the shop, which is about 720 sq ft. I plan on doing all the wiring myself and need a little advice on what kind of panel I should use? The living quarters...

Breaker size in main panel to support sub panel? [ 7 Answers ]

Hello, I am wiring a sub-panel to the outside of my home (50 feet from main 200 amp box). I ran 3 wire - 6 gauge. What is the largest 2 pole breaker I can put in the main panel to supply the sub-panel. TYPE NM-B 6-3 WITH GROUND 600 VOLTS CIRTEX-I EZ-STRIP (R) PLUS 17:11 2/5/07 SB/RC ...


View more questions Search