PBNU-LD10N060D burner does not fire

jtwittman Posts: 1, Reputation: 1

New Member

Jan 25, 2010, 05:14 PM

PBNU-LD10N060D burner does not fire

When I turn the thermostat up, the blower turns on but the burners will not fire on a model PBNU-LD10N060D furnace

Check out some similar questions!

Circulator pump works but oil burner does not fire [ 6 Answers ]

Hello, I have a 2 zone heating system, forced hot water with oil burner/boiler. Also heats domestic hot water tank/coil. Everything works fine EXCEPT zone 2, which is only the living room. When the thermostat is turned up, the circulator pump goes on but the oil burner will not. The...

Keeprite ps90-dv pilot comes on burner doesn't fire [ 3 Answers ]

When I turn the furnace on the pilot flame comes on and the burner does not fire. The pilot will cycle on and off a few times and then quit. This is an itermittent problem That is becoming more frequent. The unit is only 3 years old. Thanks for any help.

Intertherm model #1265 burner won't fire up [ 2 Answers ]

Pilot is lit,blower works,stat is good,burner will not kick in

Burner does not fire up when heat turned on [ 3 Answers ]

Hi, I have a Lennox Furnace, when you switch on the thermostat to heat and adjust the temp. accordingly, the burner does not ignite. Pilot flame is working, fan works. But no flame on the burner. Here is how the thermostat is wired (Is it right? ) RC- blue wire, G- black wire Y- red wire W-...

View more questions Search

Check out some similar questions!

Add your answer here.