Ask Experts Questions for FREE Help !
Ask
    Mikelp's Avatar
    Mikelp Posts: 5, Reputation: 1
    New Member
     
    #1

    Jan 21, 2010, 02:31 PM
    Hansa shower valve
    I installed a Hansa shower valve in a bath remodel recently. After the tile was installed I installed the trim kit. The deverter does not shift the water from tub to shower. Is this a problem that anyone else has incountered? How much water pressure does it take to make this diverter work properly?
    Thanks, Mike
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
     
    #2

    Jan 21, 2010, 03:19 PM

    I assume you have Knob on top of the spout which transfers water from spout to shower head . Correct ?
    Or do you have diverter built into the trim plate?
    Or is it individual diverter with handle someplace on the wall ?

    In all 3 cases - no, it is not normal. Tell me what type of diveter you have and we'll take it from there. Picture would be great help, too...
    Mikelp's Avatar
    Mikelp Posts: 5, Reputation: 1
    New Member
     
    #3

    Jan 22, 2010, 05:45 PM
    Milo Hi.
    The diverter on my Hansa valve is a separate valve than the mixer. It is located under the mixer valve which is where the trim handel will be connected. So the trim diverter knop you pull out to divert to shower is located below the on / off , cold/hot handel. Can't take a picture till I'm at that job again.
    Mike

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I need a replacement for a Jacuzzi Wall Shower valve and Hand held Shower [ 4 Answers ]

I have a really bad hot water leak in my tub/shower. I'm guessing that the Jacuzzi shower tower/tub are about 15 years old. Model # JAC D952000. I'm hoping to just replace the hardware. I had someone look at it today and he puzzled. He also made the leak worse than it was. Does anyone know...

What replacement valve cartridge is best for theMoen 620 shower valve? [ 0 Answers ]

What is the best replacement valve cartridge for the Moen 620 shower valve?

Stuck middle valve - 3 handle shower valve [ 3 Answers ]

Help and suggestions!! The middle handle, used to divert water from the tub spout to shower head is stuck in the 'tub' position. I have removed the handle and trim bezel and tried to turn the shaft with pliers - no luck & quit before marring the splines on the brass shaft. What now??

Using a shower valve for a tub/shower [ 2 Answers ]

I got a great deal on a nice shower valve set when my plans for a bathroom remodel included just a shower. Now the plans have changed slightly, and I'm doing a tub/shower instead. Can I just run a "T" from the outlet of the valve to both the showerhead and a diverter spout? I'm thinking gravity...

Replace shower Plumbing Valve assembly shower head 2 knobs [ 3 Answers ]

In a fiberglass corner shower shell. What I have is an old leaking rusted Shower valve assembly. It leaks from the Shower head that is a hand sprayer with a wall mount from the sprayer. It also leaks around the both the hot and cold water wall mount knobs. The cold water knob the sleeve that...


View more questions Search