Ask Experts Questions for FREE Help !
Ask
    LuisHP's Avatar
    LuisHP Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 4, 2010, 03:01 PM
    Bryant 350mav igniter
    I have a vintage Bryant 350 MAV that is temperamental. The gas will not ignite unless the igniter is in a perfect position. What is the "exact" igniter replacement part for this unit? BTW, all the items have been checked professionally, gas flow (in and out), gas pressure, air flow, air pressure, safety switches, etc. The only item that has made a difference is the angle and height of the igniter. Unfortunately, the replacement unit seems to be an after market replacement. Any ideas?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 4, 2010, 03:23 PM
    Unless the part comes in a Bryant/Carrier parts box or container and is marked the same as the container it is just about impossible to make sure you are getting a factory part. I can tell you that there are major differences between after market circuit boards from different companys but not about the differences between ignitors.

    The exact location for the ignitor is in the manufactures service manual for that furnace but the factory service manuals are not published for general consumption or available on the net as far as I know. The homeowner operating manual and some parts manuals are available but no real service manuals.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant plus 90 350mav code 34/14 [ 5 Answers ]

I have a Bryant 350mav that is giving a code 34 followed by a code 14 . I checked the intake and exhuast pipes and they are clear. What next? It is blowing cold air, cycles the 3 times and then locks again.

Repair of furnace blower for Bryant 350MAV [ 2 Answers ]

I was told by a service repair firm that the blower motor and wheel needs replacing for a Bryant Model 350MAV condensing gas furnace (10 years old). There is quite a bit of noise when it runs and the unit vibrates at bit at the blower housing. His cost was nearly $1000. I think I can do it...

Bryant 350MAV inducer housing leaking [ 6 Answers ]

I have a 13 year old Bryant 350MAV gas furnace. The 2 halfs of the inducer housing are leaking water. Can these 2 half be pulled apart and resealed? If so what special type of silicone needs to be used if any?

Bryant 350MAV only runs in the mornings [ 6 Answers ]

Hi Everyone, I have a strange intermittent problem with my Bryant 350MAV furnace that has arisen in the last couple of months, since the weather started to cool here in Los Angeles. I usually turn off the thermostat at night when I go to bed, then manually turn on the heat in the morning when...

Bryant Model 350MAV Furnace [ 3 Answers ]

Hi, I recently had a furnace repairman in who told me our inducer on our Bryant Model 350MAV furnace needed to be replaced. He said the total cost would be $1075.00, including $890.00 for the inducer. This seemed high to me. Can anyone give me an idea of what this repair should have cost,...

View more questions Search