Check out some similar questions!
Furace fan won't stop unless furnace is shut off
[ 8 Answers ]
Hi, I have Heil Ultimate II gas furnace with about 13 yrs old. The furnace is working OK except the fan would never stop as long as the furnace is on, therefore, it will blow the cold air when the heating stops. I also tried to disconnect the wire from the board, and fan will still not stop. ...
Rheem furnace,fan runs all time and doesn't fire up
[ 0 Answers ]
I have a furnace that the fan runs all the time. The thermostat doesn't turn it off or doesn't seem to control the unit. The green lights on the board are on and the orange light is not. The unit will not fire up. I have unplugged and plugged in all connection. Didn't see any problems with...
Bryant furnace fan cycles on 1 or 2 times for 2 or 3 sec. After heat cycle has ended
[ 8 Answers ]
I have a Bryant furnace Mod. #394GAD024050 and after the temp has reached the set point and the furnace has cycled off the fan will come back on a couple of times for approx. 2 or 3 seconds. In the older furnaces with a machanical fan/limit switch some times the temp would creep up and cause the...
Furnace Fan Runs Continually and Randomly
[ 4 Answers ]
Chronological Sequence of Events 1.Programmable Thermostat installed in 2007, and was working as programmed 2.New Brock Furnace installed in April of 2009. 3.Furnace has run randomly as if it has a mind of its own, since the installation 4.Sometimes the air is heated and sometimes not...
Force air furnace runs only three minutes before shut down.
[ 2 Answers ]
My Lennox elite gas forced air furnace, starts and runs about three to four minutes before shutting down, long before reaching the set thermostat temperature. View more questions Search
Add your answer here.
|