Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Repair parts for sears table saw 11327520
[ 2 Answers ]
Two questions, what is the housing that sets up on top of the motor (with the toggle switch) underneath called? Where can you get replacement parts for older Sears table saws?
Furnace comes on but not always a fan
[ 11 Answers ]
I have a small Mobile home type furnace. The flame comes on but the fan doesn't At 1st it was iintermittent Then it got worse (this was all yesterday. Under the fan is a box with a removable cover. On top there is a fan switch. Inside there is a transformer with 4 wires and 2 little quarter sized...
My gas furnace doesn't light pilot ilght come on but gas doesn't come on
[ 1 Answers ]
Gas furnace doesn't come on the fan for fresh air/exhaust and pilot light comes on but gas valve not letting gas in to burner so it doesn't light,but if I turn off power and back on three or four times it will work until house cools and need heat again
Fan blows constant on industrial ceiling gas heater
[ 0 Answers ]
I have a couple of heaters that the fan motors are staying on after burner has shutdown or even after thermostat has been turned down. This is not the couple of minutes after heating, it stays running all the time. What should I be looking for? Thanks in advance.
Fan on gas central heating unit stays on after correct temperature is reached.
[ 1 Answers ]
Fan on my York Stellar Plus Gas-fired central air unit stays on for about an hour after thermostat reaches temp and shuts off combustion. It just blows room temp air after heating to desired temp. Seems like a waste of electricity. Unit is about 10 years old and seems to otherwise work fine. Any... View more questions Search
|