 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Fan blows constant on industrial ceiling gas heater
I have a couple of heaters that the fan motors are staying on after burner has shutdown or even after thermostat has been turned down. This is not the couple of minutes after heating, it stays running all the time. What should I be looking for?
Thanks in advance. |
||||
Check out some similar questions!
Is it possible to convert a lp gas water to a natural gas water heater or will I need to get a new heater?
My neighbour has a clare brothers furnace. Model HEMI 70BD. I replaced the module for them because it was shot. The furnace fan now runs on low speed all the time and during the call for heat then goes into high. T-stat is about 18yrs old. Mercury switch. The humidifier and EAC are wired together...
I have a Hunter Ceiling Fan in my kids room that is only three months old. One day the fan stopped working and the light now only works via the pull chain. Is there a way to remove the remote receiver permanently and operate completely by the chains? Thanks.
Fan on my York Stellar Plus Gas-fired central air unit stays on for about an hour after thermostat reaches temp and shuts off combustion. It just blows room temp air after heating to desired temp. Seems like a waste of electricity. Unit is about 10 years old and seems to otherwise work fine. Any...
My pilot light has been relit twice. According to the person doing the job, he confirms that after ten minutes, the pilot has remained on. However it seems to have go off after this period. What does this mean and what can a person expect to pay in costs for parts and labor? Thank you!
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
