Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Carrier gas furnace code 31
[ 3 Answers ]
Hi. I have a Carrier gas (propane) furnace 58MCA100-11116 series 111. It shows a code 31. The evacuation blower runs for a short time then kicks off. The burners do not ignite. To date I have: replaced the pressure switch, checked in and out lines to the pressure switch for obstruction,...
My gas furnace doesn't light pilot ilght come on but gas doesn't come on
[ 1 Answers ]
Gas furnace doesn't come on the fan for fresh air/exhaust and pilot light comes on but gas valve not letting gas in to burner so it doesn't light,but if I turn off power and back on three or four times it will work until house cools and need heat again
Carrier furnace gas valve opens too late
[ 7 Answers ]
I have a carrier weathermaker downdraft heat&ac unit that fails to open the gas valve soon enough after the ignitor is glowing before it cycles through another attempt or "locks out". With the inducer motor running and ignitor glowing good either nothing else happens or a hissing noise like a...
Carrier Furnace Thermocouple
[ 2 Answers ]
I have an older Carrier home furnace that has a pilot light. I can get the pilot to light but it goes out when I let off the pilot button and before I can turn it to the "ON" position. I believe that the thermocouple may be bad but I can't ( do not know how to ) remove it from in front of the...
Thermocouple on Old Carrier Gas furnace
[ 5 Answers ]
If the thermocouple is defective, could you light the pilot and it and the burner would stay lit? How do you know it is defective? Would the defect be visible? If so, could you tell me What it would look like? The heater is 20+ years old. I have never had ONE problem with it, until I had it... View more questions Search
|