Ask Experts Questions for FREE Help !
Ask
    trucker2's Avatar
    trucker2 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 1, 2009, 07:41 AM
    York furnace burner won't stay lite
    Hello I have a older york furnace gas converted to propane it been great when turning it on everything works but when the burners light they go out in about 3 to 5 secounds dose it three time then goes to call for no heat code I've put in new flame sencor sill same think can you help thanks jim or [email protected]
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 1, 2009, 09:39 AM
    You need to test the flame sensor circuit for proper operation.
    Attached Images
  1. File Type: pdf Doc1.pdf (42.4 KB, 196 views)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm gas heater pilot lite won't stay lit. [ 3 Answers ]

I have followed the directions, yet the pilot lite won't stay on.

Furnace burner won't stay lit [ 2 Answers ]

I have an older model Night & Day model c100u series 510 gas furnace. The burner won't stay lit when the thermostat kicks on. I replaced the thermocouple but the burner still lights then immediately goes out. Any help?

Burner won't stay lite [ 1 Answers ]

I have a Maytag Neptune MDG3000AWW gas dryer that will lite in all three modes (intellidry , time dry/air fluff, and intellidry ) but will only stay lite of 8 to 10 seconds. After ltwo or three minutes it lites again for another 8 to 10 seconds. Takes all day to dry a load.

Furance won't stay lite [ 2 Answers ]

I have a beckett afg oil furance when I hit the reset button it lite run reach the temperature in the house but when temparture drop in the house the furance will lite but cut off when try to startup again it lite but just go out

HEIL furnace will not stay lite [ 3 Answers ]

I have a older heil furnace (Model#867.769445) about 20 years old. When the pilot turns on after a few seconds the burners light, then after a second or two they shut off, on again, and off. They will do this continually until finally they stay on or the furnace stops trying to heat. I have also...

View more questions Search