Ask Experts Questions for FREE Help !
Ask
    sschipper's Avatar
    sschipper Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 23, 2008, 04:14 PM
    Burner won't stay lite
    I have a Maytag Neptune MDG3000AWW gas dryer that will lite in all three modes (intellidry [regular], time dry/air fluff, and intellidry [easycare/permannet press]) but will only stay lite of 8 to 10 seconds. After ltwo or three minutes it lites again for another 8 to 10 seconds. Takes all day to dry a load.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 30, 2008, 02:02 AM
    Sounds like the safety device on the burner is bad or has lost its setting. You will probably need to call for on site service unless you can test the unit and effect the repair.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Intertherm gas heater pilot lite won't stay lit. [ 3 Answers ]

I have followed the directions, yet the pilot lite won't stay on.

Homelite mighty lite weedeater won't stay running [ 1 Answers ]

i have a Homelite Mighty Lite weedeater 1 year old...the primer bulb cracked so i finally found anothe one..i put it on and now it will start but dies..if i give it gas it dies and if i dont give it gas it dies...when it dies the motor or exhaust is smoking which i dont remember it ever doing...

Furance won't stay lite [ 2 Answers ]

I have a beckett afg oil furance when I hit the reset button it lite run reach the temperature in the house but when temparture drop in the house the furance will lite but cut off when try to startup again it lite but just go out

Replaced thermocouple furnace still won't stay lite [ 2 Answers ]

Our furnace was pushing out cold air, my husband replaced the thermocouple and now the furnace will lite, then about 20 seconds later the light will go out and the whole furnace will stop working. It is a Coleman forced heat. Please give us some help

HEIL furnace will not stay lite [ 3 Answers ]

I have a older heil furnace (Model#867.769445) about 20 years old. When the pilot turns on after a few seconds the burners light, then after a second or two they shut off, on again, and off. They will do this continually until finally they stay on or the furnace stops trying to heat. I have also...

View more questions Search