 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Carrier Vintage gas furnace
Standing pilot gas valve model Vr8200H1228, found "X" terminal to valve, conductor on othe terminal disconnected from control board, NO pilot, no nothing. What location would the other conductor be replaced, 24v trans normal terminal points X R B Y W any place to get older Carrier wiring diagrams? Trying to help a friend with no cash.:D
|
||||
Check out some similar questions!
Blower runs, furnace won't ignite. ( pilot light IS WORKING) 1. filter was cleaned 2. thermostat reprogrammed . Is there anything we can do beafore calling service?
My Carrier 58SS gas furnace starts up and lights up the burners and operates normally for 2 minutes, then the burners shut down but the igniter and pilot light continue indicating the thermostat is requesting the furnace to heat up the house. I changed thermostats to see if that was the problem...
I have a 58TUA120 Carrier Gas Furnace. It keeps going out on code 32 (pressure switch). I have replaced the low fire pressure switch, checked the flue (it's completely clear) and the control board. Carrier technical support is taking days to get back to me. Any suggestions?
I have a 80% Carrier furnace! I have to shut off the power some times for it to start up again! Then I have to turn the thermostat way up for it to go!! Do I have a bad stat or do I need to replace the ignighter and or the glow plug?
I have a Carrier Furnace that will not light. It has an electronic igniter. I turn the power off and on and the blower works but it will not ignite. It cycles two or three times and turns off. It has a red light that blinks on and off intermittently.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
