Ask Experts Questions for FREE Help !
Ask
    ccm80's Avatar
    ccm80 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 1, 2008, 01:58 PM
    80% carrier furnace
    I have a 80% Carrier furnace! I have to shut off the power some times for it to start up again! Then I have to turn the thermostat way up for it to go!!
    Do I have a bad stat or do I need to replace the ignighter and or the glow plug?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 1, 2008, 02:01 PM
    If you have a flame sensor clean it first and see if that takes care of it.
    acetc's Avatar
    acetc Posts: 1,004, Reputation: 79
    Ultra Member
    		  
    #3

    Jan 1, 2008, 04:22 PM
    `If you have to unplug it ,that tells me it is going into lockout, before you unplug the furnace check the number of flashes and look on the furnace door for the corresponding problem. Mike
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier furnace [ 2 Answers ]

Blower runs, furnace won't ignite. ( pilot light IS WORKING) 1. filter was cleaned 2. thermostat reprogrammed . Is there anything we can do beafore calling service?

Carrier furnace [ 1 Answers ]

My carrier furnace glow plug cames on but no flames.

Carrier Furnace [ 1 Answers ]

Motor runs, pilot light won't ignite. Led blinks no clue what it means after 5 minutes the motor stops.

Carrier furnace [ 1 Answers ]

I have a Carrier Furnace that will not light. It has an electronic igniter. I turn the power off and on and the blower works but it will not ignite. It cycles two or three times and turns off. It has a red light that blinks on and off intermittently.

View more questions Search