 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore 70 series, won't fill with water, drains out as fast as it's put in
I have a kenmore series 70 washer, has good water flow to the bowl, but the water runs out as fast as it is put in. it's like the dump valve is stuck.
What is causing the issue so I can replace it. Thanks Sandy |
||||
Check out some similar questions!
Starts, stops, spins, and flushes out water appropriately - but won't let water in, neither hot nor cold, on any program / cycle. Any ideas? Need to fix it myself to keep housepeace...
Hello, I have an older Kenmore 80 model no 110.82683810 top load washer. The problem is: I cannot get it to fill with water. I have, at this point, replaced the timer and the water inlet valve. This has not resolved the issue. I have checked the water level switch and it works fine. I can use...
We have a Kenmore Elite that we bought in 2003. The washer has worked great until this week. The washer will attempt to fill with water once we select the cycle but it appears as if the drainage holes at the bottom are open and draining the water as fast as it can pour into the washer... hence, the...
Run water in tub drains. Fill tub does not drain use snake but its still the same
I have a top loading washer and the last time I put clothes in to wash, the water started "filling" the tub right away, so I went upstairs to bed. In the morning, the water was still "filling". The timer did not turn it off after the timed cycle. There was some water on the floor, but not over 8...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
