Ask Experts Questions for FREE Help !
Ask
    7up's Avatar
    7up Posts: 180, Reputation: 1
    Junior Member
    		  
    #1

    Sep 29, 2009, 10:37 PM
    Bearing size
    I measured my crankshaft journals with a digital caliper and the readout was(2.435mm),so now with that number how do I find out what size bearings do I need?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Sep 29, 2009, 11:48 PM

    Usually the bearing number is all you need. I have a place nearby, that I can get bearings from and all I need is the number AND you can't tell them it's for a car.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Beam size to replace load-bearing wall [ 13 Answers ]

Okay, I'm trying to decide if it's worth the trouble to open up a room in my basement. It is currently a 16 ft wide wall with a single doorway in it. It is a load-bearing wall. I'd like to open up the doorway to about 10'6" width. The wall supports the floor above, and there is another...

Bearing size [ 1 Answers ]

I have a 72 gmc truck with a 350small block 4brrl carb with low oil pressure I'm running std bearings now I've tried 10's no good so I went back to std but did not turn the crank with 10's on but I'm still getting low oil readings the pump is new and in the morning I check the oil and it reads...

Header size for load bearing wall [ 2 Answers ]

I live is a colonial 2 story home. I am currently remodeling my kitchen/dining room. I currently have a header of 68 inches on the load bearing wall between my dining room and living room. I want to open that up to 84 inches. Can I use dimensional lumber to frame out the header and if so what...

What size headers for interior load-bearing walls? [ 2 Answers ]

I would like to cut out a large part of an interior laod-bearing wall that currently separates the kitchen from the dining/living areas. The section of wall I would like to renovate is about seven feet long, and I would expect to frame it with a stud and double jack studs at each side of this...

Max pipe size in load bearing walls [ 2 Answers ]

I have a 2" line stubbed for a drain in an area of a 15' basement that will be framed 8' high with the rest used for storage above. Are these walls now considered load bearing? What's the maximum size pipe I can run through a load bearing 2x4 wall assuming I'm using a protective plate.

View more questions Search