Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Tap into Cast Iron Vertical Stack
[ 11 Answers ]
I am considering taping into one of my cast iron stacks to add a drain. The cast iron is in very nice condition and has no problem. It runs into concrete on the bottom, the other side of the pipe has extensive plumbing connections attached to it, then it vents. Would the best thing to do be to...
Replace 1.5" galvanized steel (male threads) to 4" cast iron stack
[ 1 Answers ]
I need to replace a drain line from an old double cast iron kitchen sink. The existing pipe is 1.5" galvanized steel which threads directly into female threads on a 4" cast iron stack. The male threads of the galvanized pipe broke off in the cast iron. I'm guessing the easiest solution is to...
Can I replace part of my cast iron sewer stack.
[ 3 Answers ]
I have a hopefully not too stupid question about replacing part of my cast iron sewer stack. I have a 50+ year old house with roots in my sewer pipe causing some backup thought the basement drain. I used root killer in the drain and several weeks later had a mat of small roots flush back up...
Cast iron soil stack to pvc
[ 15 Answers ]
the plumbing in our house is from 1936. We noticed a large stain in the ceiling, tore it out to reveal the cast iron soil stack (runs from the upstairs bathroom turns a corner then runs straight to the basement) and found the leak was around (very bad leak) the lead joint. My husband finally got...
Cast iron vent stack
[ 7 Answers ]
I'm installiing a new basement bathroom and when running a vent stack I would like to tap into the existing cast iron with PVC using a saddle on the cast. My question is what method is used to cut a hole in the cast iron, where I wish to place the saddle and connect the PVC. View more questions Search
|