Check out some similar questions!
Hunter Fan Model 23282 - Wire Hunter Control Model 27182
[ 3 Answers ]
I have a new house that came pre wired for a light/fan. I connected my Hunter Fan (Model 23282) to the ceiling wiring as such FAN/Ceiling Wiring White/White Black/Black Black-White/Red Green/Green I believe I wired the celing correctly.
Hunter fan w/ light & reversing switch on remote, remote not working properly
[ 1 Answers ]
Hi, I have a Hunter fan with light and remote control, with reversible switch on the remote. RC was working fine until recently, and now, the fan will not turn off with it. I do not have a wall switch. The light works fine with RC, and the reversing also works, so does the fan speed. So, what...
Heat Pump A/C not working after Replacing Honeywell T841A w/Hunter 4460
[ 1 Answers ]
Heat seems to work fine, although fan continued to run after outside unit shut down and heat always seems to use heat strips in air exchange unit. A/C will not turn on at all, heat pump or fan T841A 44660 R to RH O to Y/O W2 to W/B (W2 jumped to E)
Hunter remote not working
[ 2 Answers ]
Hunter ceiling fan.its a round receiver under lite kit . Model cp-911or ser.218109. Alls will do is make motor humming noise no movement or lites. New battery. Checked continuity all pins are hot when wall switch is on.
Thermostat - Honeywell to Hunter - Condo - Not working."
[ 5 Answers ]
Hello... I am trying to replace an old Honeywell T8195B with a Hunter 44110. This is located in a condominium with the A/C unit on the roof and the fan and elec. Heating unit in the ceiling. I have located the thermostat wire in the ceiling and it is split and wired as indicated in this... View more questions Search
Add your answer here.
|