Ask Experts Questions for FREE Help !
Ask
    lynnettefrance's Avatar
    lynnettefrance Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 11, 2009, 12:32 PM
    New washer overflows drain pipe
    I replaced an old washing machine that drained with no problem into my wall drain pipe. When the new washer was hooked up, the drain pipe could not handle the volume of water and overflows. If I put the washer on slow setting, it drains fine.

    I had a plumber out to check and see if I had any clogs. He confirmed there were no clogs. He did, however, state that the newer washing machines drain much faster than the old ones and older plumbing drain pipes cannot handle the water flow. Apparently, new building codes require larger drain pipes now.

    Any suggestions for how to fix this problem? I just leased my house to a new tenant who doesn't have a slower speed setting on their washer. Any help would be appreciated.
    afaroo's Avatar
    afaroo Posts: 4,006, Reputation: 251
    Ultra Member
     
    #2

    Sep 11, 2009, 01:03 PM

    You need to close off the stand pipe where the washer drain connects to with a compression fitting, (see image) or I caulked the hose in with rags and sealed it with duct tape. This makes a water tight connection between the washer and the stand pipe, or wait until the other expert's gets on line good luck.

    John
    Attached Images
     
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #3

    Sep 11, 2009, 01:52 PM
    Your plumber was correct. The older washer stations can't handle the newer stronger pumps.
    There is a inexpensive solution to this. I had to do it myself on my own washer and countless of our clients has had to do the same thing. In all the years that we have been advising connecting the washer hose to the stand pipe and turning it into a closed system we have never got back a single complaint.
    This forces the water ,under pressure, to exit the washer without backing up.
    This can be done by attaching the washer hose by a compression fitting or other fittings that use hose clamps,(see images).
    Until you can pick up a fitting to close off the standpipe you can simply duct tape the hose but this is just a temporary hookup. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Washer Overflows in an unusual washer drain [ 6 Answers ]

HI My wife and I moved into a home that was built in the 50's and before we moved (aug 2006) in we had the septic checked and it was completely empty. All the drains in the house drain fine except for the washer drain overflows. It is an unusual or atypical drain than what I am used to seeing....

Toilet Drain Pipe overflows when I flush or drain tub.why? [ 2 Answers ]

When I flush the toilet or drain the tub in my upstairs bathroom, the water overflows from the toilet drain pipe. I snaked this drain after removing the toilet, but the water is still backed up to near the top of the drain pipe. It will slowly drain, but takes hours to clear the drain. Please...

Washer drain overflows [ 2 Answers ]

Ok my problem is that my washer vent drain overflows. It is on an outer wall, it leads into a crawlspace where it joins the rest of the drainage systen for the house. No other drains back up and we are not obn septic here. Any ideas?

Maytag washer: drain pipe overflows during rinse cycle HELP! [ 2 Answers ]

:eek: I have a new Maytag washer. (top load). During the drain cycle I hear the water pumping out but then the water comes back and will overflow at the top of the pipe and on the floor. The old washer did not have this problem. We used a snake, draino etc etc. in the pipe. Sometimes it will NOT...

Washer stand pipe occasionally overflows [ 1 Answers ]

There doesn't seem to be any real rhyme or reason to this happening except that it seems to occur when we either run a very large load or if we happen to run a small load of laundry but still had the water level set for high or extra-high. However, it doesn't overflow every time this situation...


View more questions Search