Ask Experts Questions for FREE Help !
Ask
    vincekelty's Avatar
    vincekelty Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 7, 2009, 12:57 PM
    Intermittent Operation of Submersible Pump
    Why does my 1/6 HP submersible pump keep operating in a pulsating "on and off" cycle?

    It runs for a few seconds, then stops operating and then runs again. This cycle continues in a three second cycle.

    Is it repairable? Should I replace it?

    Thanks for your help.

    Vince Kelty
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #2

    Aug 7, 2009, 05:28 PM

    1. Does your pump do this all the time, or only when water is being used?

    2. If it is only when water is being used, as is probable, then you should check your pressure tank. It is likely waterlogged, meaning it has very little, or even no, air above the water. You should have a pressure valve towards the top of the tank. Press it for a few second and see if water comes out. Get back with your results.
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #3

    Aug 7, 2009, 05:32 PM

    How high is the lift? How big is the pipe? Does it have a check valve? Could be that the pump pumps the water up the pipe, shuts off. The water flows back down the pipe and raises the float and the cycle starts over again.

    Is this a sump pump?
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #4

    Aug 7, 2009, 10:38 PM

    What float are you referring to?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
    		  
    #5

    Aug 8, 2009, 06:14 AM

    Guess I'm reading this as a sump or utility pump. Not as a well pump. OP said 1/6 HP.
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #6

    Aug 8, 2009, 06:16 AM

    You might very well be right about that. It hadn't occurred to me. The 1/6 HP did seem awfully small.
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
    		  
    #7

    Aug 8, 2009, 06:20 AM
    Yeah! I picked up on the low horsepower myself. This could be a sump or portable lift pump. I don't think he's talking about a submersible house pump.
    How about it Vince! Care to let us in on what type of pump you have? Regards, tom
    jlisenbe's Avatar
    jlisenbe Posts: 5,020, Reputation: 157
    Uber Member
    		  
    #8

    Aug 8, 2009, 10:36 AM

    It has always struck me as strange that people on this site will post a question, then all of us get into a discussion about it, but the person never responds.

    Oh well. I do enjoy reading the comments of others.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier Weathermaker 8000 intermittent operation [ 13 Answers ]

Hello, I have a Carrier Wethermaker 8000 gas furnace. Over the past week or so, I've noticed that the temperature in my house drops into the low 60's (I usually keep the thermostat on 68/69) and the furnace never kicks on. The thrmostat itself seems to be OK. The problem is intermittent at this...

Noisy intermittent furnace operation [ 1 Answers ]

I have a York Stellar Central Environmental Heating/Cooling system installed in April of 1994. Model number is G/CN060SA. The unit sends strong vibrations through the floor when it is running, and occaisionally just makes a buzzing noise without generating any heat. I have found that by...

Intermittent Blower Operation [ 1 Answers ]

Sometimes, the air handler blower does not run when the condenser unit turns on. Setting the blower to ON does not help. When the blower does turn on, setting it to ON will keep it running when the condenser cycles OFF. What could cause this problem?

Intermittent blower operation [ 3 Answers ]

Hello, I have a Janitrol model A30-08 furnace. On the AC side, when the thermostat calls for cooling, sometimes the blower kicks on, sometimes not. The evaporator coils always cool down (to the point of icing if I don't intervene), so that part is working fine. When the blower doesn't come on,...

View more questions Search