Ask Experts Questions for FREE Help !
Ask
    dan619's Avatar
    dan619 Posts: 2, Reputation: 1
    New Member
     
    #1

    Jul 19, 2009, 11:47 AM
    2003 F-250 engine performance problems
    My 2003 Ford F-250 6.0 diesel is fine when it is cold, but after it gets hot the engine hesitates and losses power. If I press down on the gas is runs fine for a minute. This mainly happens in the 1800-2300rpm range. I took it to a Ford dealer and they replaced the EGR valve and installed an injector pressure control sensor to the tune of $900. The problem appears to be getting worse. What is my next move?
    TxGreaseMonkey's Avatar
    TxGreaseMonkey Posts: 16,761, Reputation: 5597
    Uber Member
     
    #2

    Jul 19, 2009, 12:57 PM

    Most problems with the 6.0 are caused by lack of maintenance, such as not performing regular oil changes. I would only use full-synthetic diesel HDEO in any turbo diesel. The two most common problems are with the injectors and the turbo--they have oil fired injectors. Therefore, not changing the oil as scheduled, or letting it get low, will cause problems by clogging the three “micro-screens” that are in each injectors. Dirty oil causes a build-up in the “veins” of the turbocharger, causing them to stick--then turbo issues really begin. These trucks are not “grocery getter” trucks for short trips-–they need to be opened up and run.

    The link below may help:

    https://www.askmehelpdesk.com/cars-t...ml#post1415281

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

2003 Nissan Altima Engine Blown? [ 6 Answers ]

We have a 2003 Altima. The oil light was flickering on and off for about 3 days. On Wednesday we were driving home and the car wouldn't accelerate. We got off the expressway and the car just died. We checked the oil and it was totally dry. We bought some oil and put 3 quarts in. The car...

Briggs and Stratton 14.5 HP mower engine poor performance [ 1 Answers ]

I am just getting my rider mower running after two years sitting. I put in new gas, flush gas line, new gas filter, new plug, new oil, new oil filter. Would only start with starter fluid. I cleaned out carburator, drained gas, spray with carb cleaner, re-assembled. It starts now but only runs...

SPORATIC engine performance [ 1 Answers ]

Hello Folks, I have a 1980 / 5hp. Briggs snow blower with auger and exhaust shoot. I just thoroughly cleaned, and soaked the carb, and then reassembled with a new fuel pump kit . It now runs, after priming it through the spark plug hole. After its warm, 1 in 10 tries pulling the cord will start...

2003 Altima-Service Engine Soon [ 2 Answers ]

I have a 2003 Nissan Altima 2.5 S and the service engine soon light came on right at 100,000 miles... it has performed flawlessly since day one. It has a small hesitation at take off but then immediately has its normal pep. I didn't take it in for the recall and was wondering if it could be that...


View more questions Search