Ask Experts Questions for FREE Help !
Ask
    egarcia_23's Avatar
    egarcia_23 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jul 6, 2009, 06:16 PM
    No heat.
    I have a Maytag Neptune gas dryer model#MDG9800AWW. The igniter comes comes on and there is a flame for about a minute and then goes out.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jul 6, 2009, 07:07 PM
    It could be the operating or safety thermostat kicking out. You will need the proper tools and know how to use them to do the repair.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Unit conversion of specific heat to heat transfer coefficient (U factor) [ 1 Answers ]

I would like to know the conversion of "Specific Heat"(KJ/Kg/K) to "Overall Heat Transfer Coefficient"(W/m2/K) for the calculation of heat load. Looking forward for the answers. Immediate reply would be appreciated. Thanks, Rupesh

Carrier Hvac heat pump with aux/em heat- NO AUX HEAT [ 1 Answers ]

I have tried to install Honeywell 7500d thermostat. I get heat pump heat but no emergency heat although the termostate is calling for it. The installation manual says to see authorized agent if I have a dual 0/b on existing thermostat and another wire is attached to common. As of now, I have ...

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Hunter 44155C Wiring - A/C turns on during heat cycle or heat will not shut off [ 0 Answers ]

Trying this again with the correct thermostat specs. Sorry, guys! It's a Hunter 44155C and the wires I have going into it are: White - W/B Red - Rh Green - G Yellow - Y1 Jumper from Rh-Rc


View more questions Search