Ask Experts Questions for FREE Help !
Ask
    sheckybaby's Avatar
    sheckybaby Posts: 4, Reputation: 1
    New Member
    		  
    #1

    Jun 7, 2009, 07:43 AM
    Heatpump not working
    Hi, First,let me say that I am ignorant in this area.
    I have a older heat/air system and had new motor installed 2 yrs ago. (2nd time in 5 yrs)
    Always say the bearings are shot. Anyway, went to switch from heat to air again this year,and the same thing. Inside blower working, fan outside not coming on. Any help is appreciated...

    Thanks -ron
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Jun 7, 2009, 08:27 AM

    Could just be the capasitor.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #3

    Jun 7, 2009, 08:28 AM
    http://img.diytrade.com/cdimg/377701..._Capacitor.jpg


    Look to see if there is a burnt wire, or the top is swollen. It will be in the electric pannel on your outdoor unit.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman heatpump [ 3 Answers ]

May be a dumb ? But new to me. Does a heat pump run in the same pressures even if its in heat mode? I have a unit low on freon charged it as much as possible.. outside temp is 50 degrees. The highest the low side would go would be about 28 degrees on the r-22 gauge. Is that normal or should it get...

Heatpump not working [ 4 Answers ]

I have a lennox heat pump and when it is turned on in the heat mode the head pressure goes up 500psi and compressor starts to over amp but when it is turned over to coolling the unit runs fine it is a 410a unit

Heatpump not working - not putting out heat [ 1 Answers ]

Last summer we had a leak in the ac - we gased up and it worked fine. Now that it is cold, i keep my heater on 64* , this morning my heater was not working and not warming the house. I raised the thermostat to 70* and still no action. Went outside - frost around the unit and fan not...

Outside condenser (heatpump) not working in cooling mode [ 2 Answers ]

My Goodman heatpump consonsor will not start in cooling mode. I have 240 volt and 24 volt at the condenser, but the unit still won't turn on when I call for cooling. The unit has a defrost circuit board. Need help. Thanks

Heatpump thermostat [ 1 Answers ]

I have a goodman heatpump with a janitrol 1890 thermostat it has never switched the aux heat on .When the temp gets too cold for heat pump to make heat .I have to turn emergency heat on myself .Book says model1860 thermostat is what should be installed is this my problem if so a new thermostat...

View more questions Search